Sparco 600 Side Mount Seat Bracket - Nissan 240SX (1989-1998) - Passenger/Right

• Fits 1989-1998 Nissan 240SX, passenger/right side
• Designed for side-mount racing seats
• Low mounting point sets the seat as low and far back as possible
• 3/16" steel, black wrinkle powder coat
• 100% bolt-in to the factory seat mounts
• Extra-low mounting point allows seat to sit between the stock chassis rails
• Sold individually. The driver side is 600SB050LL
• Not an FIA-homologated seat mount. Confirm acceptance with your sanctioning body before competition use

Disclaimers:

• Seats come in many different shapes and sizes, so not all seats will fit in all vehicles. It is up to the end user to determine if the seat will fit before ordering the seat bracket and other components.
• Many vehicles have the steering wheel offset toward the center of the vehicle. This can be accentuated when installing an aftermarket seat of a different size than the factory seat.
• Replacing a factory seat with an aftermarket seat may cause the vehicle's warning indicators to activate. This can be due to airbag, weight and/or other sensors in the factory seat that are not included in an aftermarket seat. It may be possible to eliminate these indicators with an electronic resistor, but it is up to the end user to determine if a resistor will work and which resistor to use.
• Professional installation is recommended.

The 1989-1998 Nissan 240SX has a loyal following among drivers who use their cars properly, and a real seat is part of almost every serious build. The factory seat tracks were never designed to carry a bucket, and fabricating a mount wastes time and rarely ends up square.

This Sparco 600 Series low-profile base is designed for side-mount racing seats. It sets the mounting point so the seat sits as low and as far back as the chassis allows, which is the quickest way to recover headroom with a helmet on.

It's made from 3/16" steel with a black wrinkle powder coat and bolts to the factory seat mounts. A set of side mounts is needed to complete the install.

Extra-low mounting point allows seat to sit between the stock chassis rails.

This is the passenger/right base, sold individually. The driver side is 600SB050LL. Confirm your seat's dimensions against the cabin before ordering. Removing the factory seat can trigger airbag or occupancy warning lights, which may need a resistor. Professional installation is recommended.