Planted Seat Spacer Kit - 1.5"

• Raises seat height by 1.5"
• 1/8" steel, approximately 14-3/4" L x 1-1/2" W, black powder coat
• Mounts between slider and bracket, side mount and bracket, or seat and bracket
• Runs front to back. Not for direct floor mounting
• Compatible with most major slider and seat brands
• Sold as a pair (one seat). Longer hardware required, Seat Hardware Kit recommended

Disclaimers:

• Seats and mounting components come in many different shapes and sizes. It is up to the end user to confirm fitment with their seat, sliders and brackets before ordering.
• Professional installation is recommended.

Getting a seat low is usually the goal, but not always. Shorter drivers, street cars that need better sightlines, and cars where a seat change dropped the hip point too far all benefit from a little height back. The Planted Seat Spacer adds 1.5" without changing the rest of your mounting setup.

Each spacer is made from 1/8" steel, measures about 14-3/4" long by 1-1/2" wide, and is powder-coated black. Pre-drilled slots let it sit between the slider and the seat bracket, between a side mount and the seat bracket, or between the seat and the bracket on direct-mount installs. It works with most major slider and seat brands.

The spacers run front to back, one on each side, and they mount on top of a seat bracket. They aren't designed to bolt directly to the vehicle floor, because that's the seat bracket's job. The stack gets taller, so you'll need longer bolts. Planted recommends its Seat Hardware Kit for spacer installs.

They're sold as a pair, which is enough for one seat. After raising the seat, re-check helmet clearance to the roof or cage and your harness shoulder-belt angle.